[ Back to EurekAlert! ]

PUBLIC RELEASE DATE:
27-Mar-2014

[ | E-mail ] Share Share

Contact: Florian Aigner
florian.aigner@tuwien.ac.at
43-158-801-41027
Vienna University of Technology

Ultra-thin light detectors

A new, extremely thin kind of light detectors was created at Vienna University of Technology; 2 very different technologies were combined for the first time: metamaterials and quantum cascade structures

This news release is available in German.

IMAGE: This is the schematic of the detector. The metamaterial couples the incident light to the semiconductor, and then it can be converted into an electric signal.

Click here for more information.

Subtle interactions of electrons and light make them so valuable for technology: ultra-thin systems of semiconductor layers can turn electrical voltage into light. But they can also be used the other way around and serve as light detectors. Until now, it has been hard to couple light into these layered semiconductor systems. Scientists at Vienna University of Technology solved this problem. They used metamaterials, which are able to manipulate light in the terahertz range due to their special microscopic structure.

Customized Semiconductor Layers

"Ultra-thin layered semiconductor systems have the great advantage, that their electronic properties can be very precisely tuned", says Professor Karl Unterrainer (TU Vienna). By selecting suitable materials, by tuning the thickness of the layers and the geometry of the device, the behaviour of the electrons in the system can be influenced. That way, quantum cascade lasers can be built, in which the electrons jump from layer to layer and emit a photon with each jump. Also, light detectors can be created, with a selective sensitivity to one particular wavelength.

The problem, however, is that quantum physics prohibits photons with a certain directions of oscillation (polarization) from interacting with the electrons of the semiconductor system. Light which hits the layered surface head-on, cannot influence the electron in the semiconductor. Therefore a method is required to rotate the polarization of the incident light, so that it can be detected in the semicionductor layers.

An Artificial Butterfly

This can be done with an unusual method – with metamaterials. A metamaterial has an ordered geometric structure with a periodicity smaller than the wavelength of the incident light. The light is scattered according to the structure's geometry, some wavelengths may be absorbed, others reflected. The intriguing play of colours on a butterfly's wings comes from exactly this kind of effects. Metamaterials on top of a semiconductor structure are able to rotate the polarization of the incoming light so that it can interact with the electrons inside.

IMAGE: The periodic structure and the size of the resonators in the metamaterial define the wavelenth range which can be detected.

Click here for more information.

The light used in the experiment has a considerably longer wavelength than visible light: It is radiation in the terahertz- or infrared regime, with a wavelength of about a tenth of a millimetre. This kind of radiation has important technological applications, for instance for next-generation computer technology, but it is difficult to work with these kind of waves.

A Detector on a Chip

The discovery made at Vienna University of Technology now opens up the possibility of integrating a light detector for terahertz radiation into a chip. "With conventional fabrication methods, large arrays of such detectors can be built", Unterrainer explains. They do not take up much space: Layers with a thickness in the order of magnitude of nanometers are enough to detect light – the detector is more than a thousand times thinner than the wavelength of the light which is being detected.

###

Further Information:

Prof. Karl Unterrainer
Photonics Institute
Vienna University of Technology
Gusshausstraße 25-29, 1040 Wien
T: +43-1-58801-38730
karl.unterrainer@tuwien.ac.at

Dipl.-Ing. Michael Krall
Photonics Institute
Vienna University of Technology
Gusshausstraße 25-29, 1040 Wien
T: +43-1-58801-38737
michael.krall@tuwien.ac.at



[ Back to EurekAlert! ] [ | E-mail Share Share ]

 


AAAS and EurekAlert! are not responsible for the accuracy of news releases posted to EurekAlert! by contributing institutions or for the use of any information through the EurekAlert! system.